Dimes by the dozens

I could be the richest woodworker around (and you could, too) if only I had a dime for every time …

• I measured twice, but wrote the measurement down wrong just before cutting the proverbial once.

• The one, single, solitary unfound nail in a piece of reclaimed lumber ended up being exactly in the kerf of the first cut you make.

• I needed just one more clamp of the right size for a tricky glueup.

• The very last complicated step of a very complex project was the one that causes a split.

• Broke off a brass screw.

• Got a smear of blood from a minor cut (I didn’t even know I had) on figured maple.

• Finally tossed out a 10-year-old piece of scrap, and then needed it the next day.

• Looked at a tool and realized I couldn’t remember who I borrowed it from.

• Looked for a tool and realized I couldn’t remember who I loaned it to.

• Gluing, mounting, screwing or nailing a component backward. Especially gluing. Especially when you don’t notice till the next day. Especially when you have no more of that stock to make a replacement component.

• Sanded through veneer.

• Dropped a chisel/knife/plane iron immediately after sharpening it.

• Cut on the wrong side of the cut line.

• Dropping the arbor nut down into the table saw.

• Dropping the arbor nut down into the table saw because you had to remove a blade that you just put in backward.

Now, if only I could find out who or where to turn to collect all my dimes. When I do, beer’s on me.

A.J.

COMMENTS

  1. Chuck R wrote:

    I wonder how many of these items have remedies. I haven’t broken a brass screw since I started driving a steel screw into the hole first, and perhaps a little hydrogen peroxide would mend the maple, although I have never tried it.

  2. John Gresko wrote:

    Well said A.J. I too have accomplished many of those tasks .Frustrating for sure and kinda funny but not so much at the time.

    John

  3. Rich wrote:

    OK, all amusing.

    HOWEVER

    “• Dropping the arbor nut down into the table saw because you had to remove a blade that you just put in backward.”

    BTDT, ROTFLMAO

POST A NEW COMMENT




The content of this field is kept private and will not be shown publicly.

Comments *



* Required fields
Read our Comments Policy